019-202   Metripack Connector Series

Pin Replacement

TOC

The connector can have multiple pin configurations. All types of connectors are repaired in the same manner.

 
SMALL | MEDIUM | LARGE


The connector pins can not be repaired or replaced. The connector must be replaced as a unit.

Refer to the connector replacement procedure for replacement instructions.

SMALL | MEDIUM | LARGE
   

Connector Replacement

TOC

The connector can have multiple pin configurations. All types of connectors are repaired in the same manner.

 
SMALL | MEDIUM | LARGE
   


The connectors have different keying and can not be interchanged with each other.

Before installing the new connector, perform a test fit to make sure the connector is keyed correctly.

Refer to the appropriate wiring repair kit in the service tools table in the front of Section 19 for the correct repair connector.

Refer to the wiring diagram in Section E for pin locations.

Replace one contact wire at a time. If more than one wire needs replaced, attach a lettered tag to each wire removed.

SMALL | MEDIUM | LARGE
   


Measure 152 mm [6 in] back from the face of the connector, and remove the wiring harness protective cover.

SMALL | MEDIUM | LARGE
   


Before cutting the wires, measure and tag the wires.

Use wire cutters to cut wire A 117 mm [4-½ in] from the face of the connector.

Use wire cutters to cut wire B 104 mm [4 in] from the face of the connector.

Use wire cutters to cut wire C 91 mm [3-½ in] from the face of the connector.

SMALL | MEDIUM | LARGE
   


Use crimping tool, Part Number 3822930, to remove 6 mm [¼ in] of insulation from all electrical wires.

Before installing the new connector, perform a test fit to make sure the connector is keyed correctly.

Refer to the appropriate wiring repair kit in the service tools table in the front of Section 19 for the correct repair connector.

Refer to Section E for pin locations.

Replace one contact at a time. If more than one wire needs replaced, attach a lettered tag to each wire removed.

SMALL | MEDIUM | LARGE
   


Install the terminal repair wires on the bare wires and use wire crimping tool, Part Number 3822930, to crimp the terminals.

Use heat gun, Part Number 3822860, to heat the shrink tubing. The tubing will shrink and make the connection waterproof.

SMALL | MEDIUM | LARGE
   


Wrap the wires with tape, for added protection to complete the repair.

SMALL | MEDIUM | LARGE
Last Modified:  03-Apr-2003

Leave a Reply

Your email address will not be published. Required fields are marked *