ISM, ISMe, and QSM11 – 001-012   Camshaft Gear (Camshaft Installed)

Table of Contents

Remove

Remove

TOC

Remove the gear cover. Refer to Procedure 001-031.

SMALL | MEDIUM | LARGE


Remove the camshaft idler gear. Refer to Procedure 001-036.

SMALL | MEDIUM | LARGE
   


Place two puller adapter assemblies (1) in opposite lightening holes in cam gear.

SMALL | MEDIUM | LARGE
   


Install lifting plate (11) on the holder plate (2) with one screw (8). Tighten screw securely.

SMALL | MEDIUM | LARGE
   


Attach a lifting device to the lifting plate (11).

SMALL | MEDIUM | LARGE
   


 WARNING 

The puller assembly is heavy. Use a lifting device when securing it to the cam gear.

Make sure the forcing screw pilot is engaged with the center of the camshaft and the puller adapter assembly studs are properly seated in the holder plate assembly.

Using the lifting device, position the holder plate (2) against the cam gear and install two screws (7) through the holder plate (2) into the puller adapters (1).

Tighten screws securely.

SMALL | MEDIUM | LARGE
   


 WARNING 

Cam gear and puller assembly may fall when released and cause serious personal injury.

Do not attempt to alter the puller assembly for use with any kind of impact wrench. The threads on the puller assembly may gall and seize.

Use the lever bar (4), extension bar (5), and torque reaction lever (6), to turn the forcing screw (3) clockwise, pulling the cam gear from the camshaft.

SMALL | MEDIUM | LARGE
Last Modified:  11-Oct-2005