ISM, ISMe, and QSM11 – 003-013   Rocker Lever Housing

Table of Contents

Install

Install

TOC

Use a new gasket, and install the rocker lever housing.

SMALL | MEDIUM | LARGE


Step 1: Snug all bolts.

Step 2: Tighten the 24 capscrews in the sequence shown.

Torque Value:  34  n.m  [25 ft-lb]

Step 3: Tighten the 24 capscrews in the sequence shown.

Torque Value:  61  n.m  [45 ft-lb]

SMALL | MEDIUM | LARGE
   


Install the internal engine wiring harness on the engine.

The harness and connectors must be clear of any moving parts, so the wires will not be damaged during engine operation.

SMALL | MEDIUM | LARGE
   


Connect the 15-pin connector of the internal engine harness to the 15-pin connector of the external engine harness.

NOTE: The internal and external Metri-Pack connectors are “keyed.” Make sure both connectors are correctly aligned when they are joined together.

SMALL | MEDIUM | LARGE
   


Install the holding clamps for the internal engine harness. Tighten the capscrews.

Torque Value:  20  n.m  [15 ft-lb]

SMALL | MEDIUM | LARGE
   


Install the crossheads in the same position they were removed from, and rotate the rocker levers down.

SMALL | MEDIUM | LARGE
Last Modified:  05-Jan-2009