CM850 Electronic Control System – 019-061   Intake Manifold Pressure Sensor

Slide the locking tab on the top side of the connector to the unlock position.

Press down on the tab near the end of the harness connector where the harness wires lead into the connector.

Pull outward on the connector away from the sensor to disconnect.

Use a socket or combination wrench to remove the sensor.

The sensor is located on the intake air manifold. Use the electronic service tool to monitor the sensor.

To validate this reading, a multimeter with a pressure transducer can be used to measure the pressure.

Install the sensor and tighten the capscrew.

Connect the wiring harness connector to the sensor and slide the locking tab to the lock position.

Turn the keyswitch ON.

Use the electronic service tool to monitor the intake manifold pressure sensor to ensure it is working correctly.