CM850 Electronic Control System – 019-136   Engine Brake Harness

Table of Contents

Resistance Check

Resistance Check

TOC

Disconnect the brake harness from the engine harness and from the rocker lever housing pass-through connectors.

SMALL | MEDIUM | LARGE


Insert a test lead into pin A in the brake harness.

Insert the other test lead into the corresponding engine pass-through terminal connector in the brake harness.

Measure the resistance. The multimeter must read a closed circuit (10 ohms or less).

SMALL | MEDIUM | LARGE
   


Remove the test lead from pin A and insert it into pin B.

Insert the other test lead into the corresponding engine pass-through terminal connector.

Measure the resistance. The multimeter must read a closed circuit (10 ohms or less).

If the resistance values are not correct, inspect the wires for an open circuit.

SMALL | MEDIUM | LARGE
   


Connect the brake harness to the engine harness and the rocker lever housing pass-through connectors.

SMALL | MEDIUM | LARGE
Last Modified:  13-May-2003