CM2150 Electronic Control System – 019-363   Camshaft Position Sensor

Disconnect the sensor from the engine harness. Slide the locking tab sideways. Push down on the button toward the rear of the connector and disconnect from the sensor.

Remove the capscrew that secures the sensor to the cylinder block.

Remove the sensor from the mounting location.

Inspect the camshaft position sensor for debris, cracks, or damage from contact with the tone wheel.

If there is debris on the camshaft position sensor, clean the sensor.

If the sensor is chipped, cracked, extruded, or damaged, replace the sensor with a new one.

Install a new o-ring onto the sensor.

Apply clean engine oil to the o-ring.

Install the new sensor into the mounting hole.

Install and tighten the capscrew.

Connect the sensor to the engine harness.

Slide the lock tab sideways to lock the connector to the sensor.