CM2150 Electronic Control System – 019-365   Crankshaft Position Sensor

Table of Contents

Remove
Inspect for Reuse
Install

Remove

TOC

Disconnect the sensor from the engine harness. Slide the locking tab sideways. Push down on the button toward the rear of the connector and disconnect from the sensor.

Remove the capscrew that secures the sensor to the cylinder block.

Remove the sensor from the mounting location.

SMALL | MEDIUM | LARGE

Inspect for Reuse

TOC

Inspect the engine speed sensor for debris or cracks.

If there is debris on the sensor, clean the sensor.

If the sensor is chipped, cracked or damaged, replace the sensor with a new one.

SMALL | MEDIUM | LARGE
   

Install

TOC

Install a new o-ring onto the sensor.

Apply clean engine oil to the o-ring.

Install the new sensor into the mounting hole.

Install and tighten the capscrew.

Torque Value:  25  n.m  [221 in-lb]

Connect the sensor to the engine harness.

Slide the lock tab sideways to lock the connector to the sensor

SMALL | MEDIUM | LARGE
Last Modified:  21-Aug-2006