Posted on November 20, 2022 by Jack CM2150 Electronic Control System – 019-197 Ring Terminal Table of Contents Connector Replacement Connector Replacement TOC Terminals are used on the engine harness for various connections including grounds and fuel shutoff valve supply. SMALL | MEDIUM | LARGE Next Use wire crimp tool, Part Number 3822930, to cut and remove the ring terminal connector as shown. SMALL | MEDIUM | LARGE Previous Next Use wire crimp tool, Part Number 3822930, to remove 6 mm [1/4 in] of insulation from the harness wire. SMALL | MEDIUM | LARGE Previous Next Install the proper-size ring terminal on the bare wire. The ring terminals that are included in the wiring repair kit, Part Number 3164572, are as follows: Ring Terminal Size Part No. No. 10 3823760 1/2 inch 3823761 SMALL | MEDIUM | LARGE Previous Next CAUTION Only use wire crimping pliers, Part Number 3822930, when repairing electrical terminals. Crimp the repair wire on the bare wire. Use a heat gun, Part Number 3822860, or open flame to heat the shrink tubing. The tubing will shrink and make the connection waterproof. SMALL | MEDIUM | LARGE Previous Last Modified: 03-Apr-2003 Feedback / Help