Posted on by

Cummins N14 STC, Celect, Celect Plus – Service Manual 007-025   Lubricating Oil Pan

Table of Contents

Install

Install

 TOC

Apply a 12.7 mm [0.05 in] bead of RTV sealant to the rear cover, block, front cover, and block mounting faces.

The bead must extend the full width of the flange.

SMALL | MEDIUM | LARGE


Install a new oil pan gasket.

Capscrews 1 through 6 are longer than the rest of the oil pan capscrews to accommodate the thickness of the clamping plate.

Install and finger tighten one of the 11.0 mm [7/16 in] oil pan mounting capscrews on each side of the oil pan, halfway between the front and the rear of the oil pan.

Install the clamping plate and capscrews.

Install the flywheel housing dust seal under the correct oil pan capscrews.

Install and finger tighten the remaining capscrews.

SMALL | MEDIUM | LARGE
   


Tighten the four 8 mm [5/16 in] capscrews in the rear of the oil pan in the sequence illustrated.

Torque Value:  27  n.m  [239 in-lb]

Tighten the thirty-two 11 mm [7/16 in] capscrews in the sequence illustrated.

Torque Value:  68  n.m  [50 ft-lb]

SMALL | MEDIUM | LARGE
   


Install the noise panel and lock nuts, if equipped.

Tighten the lock nuts.

Torque Value:  20  n.m  [177 in-lb]

SMALL | MEDIUM | LARGE
Last Modified:  29-Sep-2011
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.