Posted on by

Cummins N14 STC, Celect, Celect Plus – Service Manual 016-005   Flywheel

Table of Contents

Remove

Remove

 TOC

Install two 1/2 – 13 x 1 1/2 puller capscrews which have a minimum of 1 1/4-inch threaded area at points (1) and (2).

Remove capscrews (3) and (4), and install two 5/8 – 18 x 6-inch guide studs, Part Number 3824462.

SMALL | MEDIUM | LARGE


Determine the capscrew thread size, and install two “T-handles”, Part Number 3824463, into the flywheel at points (4) and (5).

Remove the remaining four flywheel mounting capscrews.

NOTE: For Rail Applications the flywheel mounting capscrews must be discarded and replaced.

SMALL | MEDIUM | LARGE
   


 WARNING 

This component or assembly weighs greater than 23 kg [50 lb]. To prevent serious personal injury, be sure to have assistance or use appropriate lifting equipment to lift this component or assembly.

Tighten capscrews (1) and (2) in alternating sequence to loosen the flywheel.

SMALL | MEDIUM | LARGE
Last Modified:  14-Nov-2011
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.