Posted on by

Cummins N14 STC, Celect, Celect Plus – Service Manual 019-063   Internal Actuator Wiring Harness

Table of Contents

Remove

Remove

 TOC

If equipped, use a Torx™ screwdriver to remove the locking capscrew that holds the Metri-Pack™ 12-pin connectors together.

SMALL | MEDIUM | LARGE


Disconnect the engine harness from the internal actuator harness connector at the front or rear of the rocker lever housing.

Release the locking tabs on the internal actuator harness connector and push the connector back through the rocker lever housing.

SMALL | MEDIUM | LARGE
   


If equipped, disconnect the engine brake harness from the engine brake solenoids.

Disconnect the engine brake harness from the internal actuator harness at the 3-pin Deutsch™ connector.

Disconnect the internal actuator harness from each of the six injector solenoids.

SMALL | MEDIUM | LARGE
   


Remove the five hold down capscrews securing the internal actuator harness to the rocker lever housing.

SMALL | MEDIUM | LARGE
Last Modified:  20-Mar-2012
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.