Cummins N14 STC, Celect, Celect Plus – Service Manual 019-081   Sensor Wiring Harness

Table of Contents

Remove

Remove

TOC

Disconnect the sensor harness AMP connector from the electronic control module (ECM).

SMALL | MEDIUM | LARGE


Remove the retaining clamp of the sensor harness from the rear of the engine block.

Disconnect the sensor harness from the intake air temperature sensor and the intake manifold pressure sensor.

SMALL | MEDIUM | LARGE
   


On engines equipped with engine brakes, disconnect the engine brake harness from the sensor wiring harness.

SMALL | MEDIUM | LARGE
   


Remove the harness retaining capscrews and disconnect the harness from the following sensors:

  • Oil pressure sensor
  • Ambient air pressure*
  • Engine position sensor
  • Engine coolant temperature sensor.

* Not used on all ratings.

SMALL | MEDIUM | LARGE
Last Modified:  20-Mar-2012