1999 GM 6.5L V8 – Crankshaft Balancer Replacement – Installation Procedure

Tools Required
J 23523-F Crankshaft Balancer Remover

1. Apply a small amount of clean engine oil the crankshaft balancer.

2. Lightly tap the crankshaft balancer into the crankshaft.

3. Use the J 23523-F to install the crankshaft balancer on to the crankshaft.

Important; When installing the crankshaft balancer bolt and washer, make sure take the curved part of the washer is pointed away from the engine.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the crankshaft balancer bolt and washer to the crankshaft.
Tighten
Tighten the bolt to 2 7 0 N-m (200 Ib ft).

5. Install the crankshaft pulley to the crankshaft balancer.

6. Install the crankshaft pulley bolts.
Tighten
Tighten the bolts to 4 0 N-m (30 Ib ft).

7. Install the lower fan shroud to the radiator. Refer to Fan Shroud Replacement (Lower) in Engine Cooling.

8. Lower the vehicle.

9. Install the drive belt on the drive pulleys. Refer to Drive Belt Replacement (6.5L Drive Belt).

10. Install the upper fan shroud to the radiator. Refer to Fan Shroud Replacement (Upper) in Engine Cooling.