1. Use the special tool (1453160) to remove the camshaft.
2. Insert the handle (1), from the flywheel side of the engine, through the hollow camshaft.
Make sure that the dowel pin in the camshaft falls into the recess (2) in the handle (1).
3. Fit the slide block (3) onto the handle (1) at the front side of the camshaft and tighten the nut (2).
– Make sure that the slide block (3) is perfectly aligned with the camshaft.
– If the camshaft has a recess as shown, use the special tool (4) (1961361) to install it.
4. Use the handle (1) to pull the camshaft carefully out of the engine toward the flywheel side.
Ask a 2nd person to help remove the camshaft.
