Paccar MX-13 – Removing crankshaft seal ring, flywheel housing

1. Clean the area around the crankshaft seal ring thoroughly.
2. Fit the spindle (A) of the special tool (1453185) onto the crankshaft flange.

3. Adjust the pin (C) with the bolt (E) until the distance (X) is 10 mm.
4. Lock the pin (C) with the nut (D).

5. Install the adapter (B) to the spindle (A).
6. Install the spacer ring (F) and secure it with the nut (G).
7. Turn the pin (C) into the adapter (B) and keep turning it until the stop is reached.
8. Repeat step 7 for the other five holes.
9. Fit screws into the hole created in the seal ring.
10. Repeat step 9 for the other five holes.
11. Remove the nut (G) and spacer ring (F).

12. Turn the bolts (H) evenly until the seal is removed.
13. Remove the special tool.

Special tools

Special tool category: Mandatory special tool for: NA region, NA Service Support

Assembly and disassembly tool set for front and rear crankshaft seals

Leave a Reply

Your email address will not be published. Required fields are marked *