SMALL | MEDIUM | LARGE Engine Family: Onan This hone maintains alignment of original bore. It reconditions cylinder bore with less stock removal. produce any finish required. 2 ½…
SMALL | MEDIUM | LARGE Engine Family: C & J, NH, NT, V28, V378, V555, V903, V504 This tool is used to cut crevice seal entry chamfer when repairing…
SMALL | MEDIUM | LARGE Engine Family: All Except B and C Series This gauge is used to check the alignment concentricity between the cylinder liner upper counterbore and…
SMALL | MEDIUM | LARGE Engine Family: ISX/Signature/QSX15/ISX CM870 Used with ST 561 Connecting Rod Checking Fixture to measure stretch and twist in the connecting rod. Ref. No. Part…
SMALL | MEDIUM | LARGE Engine Family: QST30 This kit is used for checking length, twist & bore alignment of connecting rods to help decide if they can be…
SMALL | MEDIUM | LARGE Engine Family: All K Series This special fixture is designed to measure the connecting rod bolt length during assembly and tightening of connecting rod…
SMALL | MEDIUM | LARGE Engine Family: See Below These bushing drivers are used to install and remove piston pin bushings in the connecting rods. ST 1186 Bushing Driver…
SMALL | MEDIUM | LARGE Engine Family: All Except B and C Series These ring gauges are precision ground and used to `set’ dial bore gauges, check inside micrometers,…
SMALL | MEDIUM | LARGE Engine Family: C & J, K19, NH, NT, V28, V378, V555, V903, V504 This tool is used to cut a uniform starting chamfer in…
SMALL | MEDIUM | LARGE Engine Family: See Below Locating mandrels are used to locate the connecting rod in ST 561 Connecting Rod Checking Fixture. The small mandrels fit…