Table of Contents Remove Remove TOC Install four camshaft pilots, Part Number 3824285, over the outer base circle of the valve lobes between the camshaft…
Table of Contents Remove Remove TOC Drill two 3.0 mm [0.12 in] holes 180 degrees apart in the seal casing. Use a number 10 sheet…
Table of Contents Remove Remove TOC The front crankshaft seal requires the Crankshaft Seal Replacer Kit, Part Number 4919704, for seal removal and installation. Use…
Table of Contents Remove Remove TOC Remove the four capscrews which hold the oil pan to the gear cover. Loosen all remaining oil pan mounting…
Table of Contents Remove Remove TOC Remove the ten lock nuts from the noise panel (if equipped). Remove the noise panel (if equipped) from the…
Table of Contents Remove Remove TOC Remove the three capscrews from the support. Use a rubber or plastic mallet to rotate the bearing support approximately…
Table of Contents Remove Remove TOC Remove the cam follower housing assemblies as follows: Remove the six capscrews and studs from each cam follower housing.…
Table of Contents Remove Remove TOC WARNING This component weighs 23 kg [50 lb or more. To reduce the possibility of personal injury, use a…
Tools Required • J 26999-10 C o m p re ssio n G a u g e A d ap te r • J 26999-30…
Important: The engine block surfaces must be clean. Do not use a sealer on the cylinder head gaskets. The cylinder head gaskets are manufactured with…