Table of Contents Remove Install Remove TOC NOTE: The N14 CELECT™ and CELECT™ Plus engines has one engine coolant thermostat and one aftercooler thermostat. The N14…

Table of Contents Test Test TOC  WARNING  Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C…

Table of Contents Remove Inspect for Reuse Install Remove TOC Drain the cooling system. Refer to Procedure 008-018-005. If coolant dam pressure tester, Part No.…

Table of Contents Remove Install Remove TOC The valve is in the “OFF” position when the valve is in the horizontal position. Close the manual…

Table of Contents General Information Remove Install General Information TOC Change the coolant filter at every oil and filter change interval. The correct coolant filter…

Table of Contents Initial Check Initial Check TOC Check for a blown fuse in the temperature gauge sending unit circuit. Check the wiring from the…

Table of Contents Remove Inspect for Reuse Install Remove TOC Remove the fan drive belts. Refer to Procedure 008-002-002. SMALL | MEDIUM | LARGE Next Loosen the idler pulley…

Table of Contents Remove Inspect for Reuse Install Remove TOC Loosen the capscrews which secure the fan hub shaft to the bracket. NOTE: Both two capscrew…

Cooling System Tool Number ST-1138 Belt Tension Gauge Used to check the belt tension on 11/16 to 7/8 inch width belt. Tool Number ST-1274 Belt…

Table of Contents Failure Analysis Inspection Failure Analysis Inspection TOC An analysis of used oil can help diagnose internal engine damage and determine if it…