Table of Contents Inspect for Reuse Inspect for Reuse TOC Visually inspect the fan spacer and pulley (if used) for cracks or damage. Replace if…

Table of Contents Inspect for Reuse Inspect for Reuse TOC Inspect the fan shroud for the correct fan clearance. Refer to the vehicle manufacturer’s specifications.…

Table of Contents Remove Inspect for Reuse Install Remove TOC NOTE: Do not discard the fan spacers. The spacers provide the thickness needed to install the…

Table of Contents Test Remove Install Test TOC Use a fan RPM measuring device to check the operation of the viscous fan hub. A strobe…

Table of Contents Preparatory Steps Remove Install Finishing Steps Preparatory Steps TOC Remove the cooling fan. Refer to Procedure 008-040. Do not discard the fan…

Table of Contents Initial Check Preparatory Steps Remove Install Finishing Steps Initial Check TOC This type of fan clutch is activated when zero VDC from…

Table of Contents Initial Check   Air in Cooling System Leak Test   Fan, Shutter, or Heater Air Control Valve Air Compressor Aftercooler Core Cylinder…

Table of Contents Drain Fill Pressure Test Drain TOC Position the vehicle on level ground.   SMALL | MEDIUM | LARGE Next  WARNING  Wait until the coolant temperature is…

Table of Contents Initial Check Initial Check TOC The cooling system must be designed to allow air to escape while filling the coolant system.  …

Table of Contents Remove Clean Inspect for Reuse Install Remove TOC NOTE: The N14 CELECT™ and CELECT™ Plus engines has one engine coolant thermostat and one…