Drive Units Tool Number ST-647 Standard Puller Use to remove drive pulleys, impellers, air compressor weights, etc. Tool Number 3376326 Pulley Installation Assembly Tool Use…

Table of Contents Remove Install Remove TOC Remove the water pump drive belt. Refer to Procedure 008-003. SMALL | MEDIUM | LARGE Next Remove the lock nut and the…

Table of Contents Remove Clean Install Remove TOC Drain the cooling system. Refer to Procedure 008-018. SMALL | MEDIUM | LARGE Next  WARNING  Coolant is toxic. Keep away from…

Table of Contents Remove Clean and Inspect for Reuse Install Remove TOC Shut off the sea water inlet valve.   SMALL | MEDIUM | LARGE Next Remove the screws,…

Table of Contents Clean Clean TOC Back flush the sea water passages of the heat exchanger. SMALL | MEDIUM | LARGE Last Modified:  16-Mar-2005 Feedback / Help

Table of Contents Initial Check Initial Check TOC Check the shutterstats and the thermatic fan annually for cooling system temperature actuated systems. Dual control systems…

Table of Contents Test Inspect for Reuse Test TOC  WARNING  Do not remove the radiator pressure cap until the coolant temperature is below 50°C [120°F].…

Table of Contents Inspect for Reuse Inspect for Reuse TOC Inspect all hoses for cracks, cuts or collapsing. NOTE: The silicone engine coolant hose will exhibit…

Table of Contents Initial Check Initial Check TOC Visually inspect the radiator for plugged radiator fins. Use 550 kPa [80 psi] air pressure to blow…

Table of Contents Inspect for Reuse Inspect for Reuse TOC  WARNING  Do not rotate the engine by pulling or prying on the fan. The fan…