Table of Contents Preparatory Steps Clean and Inspect for Reuse Finishing Steps Preparatory Steps TOC  WARNING  Carefully remove the capscrew. The pressure regulator spring is…

Table of Contents Test Test TOC This procedure describes a test for the operation of the lubricating oil systems for the N14 engine model. NOTE: This…

Table of Contents Remove Clean Inspect for Reuse Install Remove TOC Remove the six capscrews which connect the oil cooler support to the oil cooler…

Table of Contents Fluorescent Dye Tracer Fuel Pressure Test Fluorescent Dye Tracer TOC NOTE: This test is not effective on a cold engine, less than 21°C…

Table of Contents Remove Disassemble Clean and Inspect for Reuse Assemble Install Remove TOC Remove the oil transfer tube. Refer to Procedure 007-040. SMALL | MEDIUM | LARGE Next…

Table of Contents Remove Clean Inspect for Reuse Install Remove TOC Remove the two capscrews from the flange at the oil pan and also the…

Table of Contents General Information Remove Inspect for Reuse Test Install General Information TOC Oil flow through the oil cooler is controlled by a temperature…

Table of Contents Initial Check Test Initial Check TOC Install an oil temperature sending unit: Drain the oil from the oil pan. Refer to Procedure…

Table of Contents Drain Fill Prime Drain TOC  WARNING  Avoid direct contact of hot oil with your skin. Hot oil can cause serious personal injury.…

Table of Contents Remove Clean Inspect for Reuse Install Remove TOC Remove the demand flow cooling (DFC) signal line. SMALL | MEDIUM | LARGE Next Clean TOC  CAUTION  Wear…