Table of Contents Remove Remove TOC Remove the clamping plate, crankshaft pulley, and vibration damper. Refer to Procedure 001-022 in Section 1. SMALL | MEDIUM | LARGE Last Modified:  23-Jan-2009…

Table of Contents Remove Remove TOC Remove the five capscrews, clamping ring, seal, and gasket. SMALL | MEDIUM | LARGE Last Modified:  23-Jan-2009 Feedback / Help

Table of Contents Remove   Slip Fit Interference Fit Remove TOC Slip Fit Remove the freon compressor drive belt, if equipped. Refer to the manufacturer’s…

Table of Contents Remove Remove TOC The internal engine harness is located inside the rocker housing. A pass through connector joins the internal and external…

Table of Contents Remove Remove TOC Disconnect the injector wires. Number the injector electrical connections as they are removed. They must be connected to the…

Table of Contents Remove Remove TOC NOTE: This action applies only to engines built with cast-iron supports. Install a piece of 1/4-inch key stock 457 mm…

Table of Contents Remove Remove TOC Mark the position of the valve push tubes and injector push rods as they are removed. The push tubes…

Table of Contents Remove Remove TOC Disconnect the solenoid power and ground wires from the terminals on the inside of the rocker lever housing spacer.…

Table of Contents Remove Remove TOC Remove the air piping from the intake manifold. Remove the hose from the crankcase breather. SMALL | MEDIUM | LARGE Next Remove the…

Table of Contents Remove   With EGR Without EGR Remove TOC With EGR Remove the tube support bracket capscrew and bracket. Remove the tube from…