Table of Contents Stall Speed Check Time Speed Check Stall Speed Too Low Stall Speed Too High Stall Speed Check TOC Converter Transmissions Stall…
Category: N14 STC, Celect, Celect Plus – Service Manual
Table of Contents Initial Check Remove Clean and Inspect for Reuse Install Initial Check TOC Remove the wire. Make sure the remaining wire connection nut…
Table of Contents Remove Install Remove TOC Mark the angle of the VS throttle lever on the VS throttle shaft. Remove the VS throttle lever.…
Table of Contents Adjust Adjust TOC Remove the throttle linkage from the throttle lever. Hold the VS lever counterclockwise in the idle position. Move the…
Table of Contents Adjust Adjust TOC CAUTION Do not make any adjustments to the throttle stop screws. If the throttle does not break over correctly,…
Table of Contents Remove Install Remove TOC Remove the fuel inlet connection and pulsation damper or the filter head damper assembly. Discard the rubber o-rings.…
Table of Contents Adjust Adjust TOC To check the engine speed, use digital tachometer kit, Part Number 3375631, or optical tachometer, Part Number 3377462. SMALL | MEDIUM | LARGE…
Table of Contents Adjust Adjust TOC To adjust the VS idle speed, remove the locknut and jam nut from the screw in the rear of…
Table of Contents Remove Install Remove TOC If the check valve in the gear pump return elbow stays open or closed, replace the elbow. SMALL | MEDIUM | LARGE…
Table of Contents Preparatory Steps All Applications Remove CELECT™ or CELECT™ Plus STC Clean and Inspect for Reuse All Applications Install …