Table of Contents Remove Remove TOC Remove the coolant temperature sensor from the thermostat housing. SMALL | MEDIUM | LARGE Last Modified:  03-Oct-2011 Feedback / Help

Table of Contents Remove Remove TOC Remove the fan drive belts. Refer to Procedure 008-002 in Section 8. SMALL | MEDIUM | LARGE Next Loosen the idler pulley shaft…

Table of Contents Remove Remove TOC NOTE: Optional two capscrew or four capscrew designs are available. Remove the capscrews and the fan hub. SMALL | MEDIUM | LARGE Last Modified:  14-Sep-2011…

Table of Contents Remove Remove TOC Loosen the capscrews which secure the fan hub shaft to the bracket. NOTE: Both two capscrew and four capscrew designs…

Table of Contents Remove Remove TOC The following procedure is without removing the rear cover plate: Drill one or more holes into the rear crankshaft…

Table of Contents Remove Remove TOC Remove capscrews (1) and (2), and install two 3/8-18 x 4-inch guide studs, Part Number 3824462. SMALL | MEDIUM | LARGE Next Remove…

Table of Contents Remove Remove TOC Install two 1/2 – 13 x 1 1/2 puller capscrews which have a minimum of 1 1/4-inch threaded area…

Table of Contents Remove Remove TOC Remove the piston cooling nozzles. Remove and discard the o-rings. SMALL | MEDIUM | LARGE Last Modified:  12-Sep-2011 Feedback / Help

Table of Contents Remove Remove TOC Remove the four capscrews and housing. SMALL | MEDIUM | LARGE Last Modified:  12-Sep-2011 Feedback / Help

Table of Contents Remove Remove TOC Loosen four mounting capscrews and remove the transfer connection from the water pump. SMALL | MEDIUM | LARGE Last Modified:  23-Nov-2011 Feedback / Help