Table of Contents Remove Remove TOC  CAUTION  Record all programmable parameters, features, and calibration information from the old ECM before disconnecting the harness connectors. This…

Table of Contents Remove Remove TOC Disconnect the sensor harness AMP connector from the electronic control module (ECM). SMALL | MEDIUM | LARGE Next Remove the retaining clamp of…

Table of Contents Remove Remove TOC If equipped, use a Torx™ screwdriver to remove the locking capscrew that holds the Metri-Pack™ 12-pin connectors together. SMALL | MEDIUM | LARGE…

Table of Contents Remove Remove TOC Clean the STC oil control valve and the surrounding area before removing it from the engine. SMALL | MEDIUM | LARGE Next Remove…

Table of Contents Remove Remove TOC Remove the two capscrews from the front engine mounts and the support bracket. Raise the front of the engine…

Table of Contents Remove Remove TOC Remove one of the capscrews that hold the vibration damper and the pulley to the crankshaft. Install a guide…

Table of Contents Remove Remove TOC Remove the freon compressor drive belt, if equipped. Refer to the OEM service manual. Remove the pulley retaining nut.…

Table of Contents Remove Remove TOC Remove the coolant inlet transfer connection from the water pump. SMALL | MEDIUM | LARGE Next NOTE: The water pump must be removed carefully…

Table of Contents Remove Remove TOC Remove the coolant lines from the air compressor, cylinder block, and water pump. SMALL | MEDIUM | LARGE Last Modified:  03-Oct-2011 Feedback / Help

Table of Contents Remove Remove TOC Remove the upper radiator hose from the thermostat housing and disconnect the air compressor coolant return line from the…