1. Fully submerge the new valve lifters in lubricating oil. 2. Fit the new valve lifters through the camshaft bore of the cylinder block. 3.…

1. Carefully fit the oil nozzle, and tighten it to the specified torque. – Do not reuse oil nozzles. – Install the new oil nozzle…

1. Use the special tool (1903018) to turn the crankshaft counterclockwise as seen from the distribution side. This corresponds to the direction of rotation of…

– Attachment bolts may only be reused when a new nut can be screwed by hand over the complete cleaned bolt thread. – Apply a…

1. Clean the threaded holes for the main bearing cap bolts. 2. Lubricate the bearing shells with clean engine oil. If installing a new crankshaft,…

1. Place the lower axial bearing sections onto the 7th main bearing cap as shown. Use clean engine oil to mount the bearing sections.

1. Place the upper axial bearing sections to the engine block at the 7th main bearing. Use clean engine oil to mount the bearing sections.

If the crankshaft has been ground, fit the correct oversize bearing shells. 1. Thoroughly clean all grease and preservative from the bearing shell contact surfaces.…

1. Remove the guide adapter (O). 2. Install the guide adapter (C). – Align the guide adapter (C) with the camshaft bore by pushing the…

1. Camshaft bearings 2 to 6 must be installed in the same way as the 1st camshaft bearing. The difference is that the adapter (A)…