1. Check the camshaft bores for burrs and damage and correct if necessary. 2. Lubricate the stamp (K) and position the 1st camshaft bearing on…

– The engine block is fitted with seven camshaft bearings; the first bearing is located at cylinder one. – The following parts of the special…

1. Apply the specified grease to the lower half of the cylinder liner. 2. Lower the liner carefully into the engine block until it rests…

Do NOT install a shim ring or vibration damper in combination with a camshaft with integrated shim ring, to prevent the idler gear from touching…

1. Remove the guide adapter (O). 2. Install the guide adapter (C). – Align the guide adapter (C) with the camshaft bore by pushing the…

1. Camshaft bearings 2 to 6 must be installed in the same way as the 1st camshaft bearing. The difference is that the adapter (A)…

1. Check the camshaft bores for burrs and damage and correct if necessary. 2. Lubricate the stamp (K) and position the 1st camshaft bearing on…

1. Position a dial gauge on the vibration damper. 2. Press the crankshaft into the block until the dial gauge stops moving. 3. Zero the…

1. Position the engine upside down. 2. Mark the main bearing caps so that they can be refitted in the same position. 3. Remove the…

1. Camshaft bearing 1 is removed in almost the same way as camshaft bearing 2 to 6. The difference is that camshaft bearing 1 is…