Checking flywheel contact surface 1. Check the contact surface for visible cracks or damage. – If damaged, the flywheel may be turned down until the…

1. Use the special tool (1903018) to turn the crankshaft counterclockwise as seen from the distribution side. This corresponds to the direction of rotation of…

Special tools Special tool category: Mandatory special tool for: NA region 1809948 Auxiliary tool for height measurement of cylinder liner Cylinder liner height gauge block.…

Tighten to 50 Nm [443 lb-in] in two phases in the specified sequence : 1. Phase 1: 25 Nm [221 lb-in] 2. Phase 2: 50…

This procedure describes the correct method of repairing the cylinder liner seat by machining. The following procedure is carried out using a cylinder liner seat…

This procedure describes the correct method for measuring the cylinder liner height in the event of cavitation. Only start with this procedure when the height…

1.  Check the inlet manifold for oil deposit and debris, and clean, if necessary. 2. Remove the gasket remnants from the cylinder head. – Use…

1. Remove the gasket remnants from the cylinder block. 2. Clean the sealing surface of the cylinder block. – Use only brass scrapers or brass…

Loosen the cylinder head bolts in the sequence, as shown.