Posted on by

Centinel System – Repair Manual – 001-080   Gear Cover, Lower

View Related Topic

Table of Contents

Install

Install

 TOC

Install a new strip seal.

Orient the overlap joint to the upper left of the gear housing as shown.

Use a small amount of RTV at the overlap joint of strip seal.

SMALL | MEDIUM | LARGE


NOTE: Do
not tighten the capscrews until the new crankshaft seal is installed. The crankshaft seal
must be installed first to locate the gear cover properly.

Position the lower gear cover with the 15 capscrews. Hand-tighten the capscrews.

SMALL | MEDIUM | LARGE
   


Install a new crankshaft seal. Refer to Procedure
001-023 (Crankshaft Seal, Front) in Section 1.

SMALL | MEDIUM | LARGE
   


Tighten the 15 capscrews in the sequence shown.

Torque Value:  28  n.m  [248 in-lb]

SMALL | MEDIUM | LARGE
Last Modified:  10-Dec-2007
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.