Centinel System – Repair Manual – 001-081   Bracket, Retaining Brace

Remove the two capscrews from the retaining brace bracket and the gear housing.

Remove the two remaining capscrews, washers, and retaining brace bracket from the cylinder head.

Remove the engine lifting bracket from the retaining bracket.

Remove the retaining brace bracket and mounting spacers (1).

Inspect the retaining brace bracket for cracks.

NOTE: The two M10 x 1.5 x 25 capscrews attach the bracket to the gear housing. The one M12 x 1.75 x 35 capscrew and washer attach the bracket to the cylinder head through the engine lifting bracket. The one M12 x 1.75 x 30 capscrew and washer attach the bracket to the cylinder head below the engine lifting bracket.

NOTE: Tighten the capscrews hand-tight.

Install the retaining brace bracket, four capscrews, and two washers on the gear housing and cylinder head hand-tight.

Tighten the two capscrews to the gear housing.

Tighten the two capscrews to the cylinder head.

Install the two mounting spacers (1) to the upper gear cover.

Position the retaining brace bracket.

Install two capscrews into the threaded holes of the brace.

Hand tighten the capscrews.

Install the capscrew into location (1) on the cylinder head.

Position the engine lifting bracket over the retaining brace bracket and attach with the remaining capscrews (Nos. 2, 3, and 4).

Hand tighten the four capscrews.

Tighten the mounting spacer capscrews.

Tighten the four capscrews.