Posted on by

Cummins N14 STC, Celect, Celect Plus – Service Manual 008-064   Water Pump Idler Assembly

Preparatory Steps

 TOC

SMALL | MEDIUM | LARGE

Remove

 TOC

Remove the lock nut and the washer from the back of the idler pulley shaft.

Remove the adjusting screw.

Remove the idler pulley from the water pump body.

SMALL | MEDIUM | LARGE
   

Install

 TOC

NOTE: Do not tighten the lock nut until the water pump drive belt has been installed and adjusted.

Install the new idler pulley into the water pump body.

Install the washer and the lock nut onto the back of the pulley shaft.

Install the adjusting screw into the idler pulley shaft.

SMALL | MEDIUM | LARGE
   

Finishing Steps

 TOC

NOTE: Belt tension can increase when the lock nut is tightened. Do not adjust belt tension to full value with the adjusting screws.

SMALL | MEDIUM | LARGE
Last Modified:  25-Oct-2011
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.