Table of Contents Measure Measure TOC Inspect the drain lines, and make sure the lines do not have any loops and are not kinked. Remove…

Table of Contents Preparatory Steps Remove Inspect for Reuse Install Finishing Steps Preparatory Steps TOC Remove the ECM. Refer to Procedure 019-031 in Section 19.…

Table of Contents General Information Automated Cylinder Performance Test Cylinder Cutout Test Exhaust Manifold Temperature Test Exhaust Manifold Tilt-back Method General Information TOC  WARNING  Due…

Table of Contents Test   Sight Glass Method Gear Pump Drain Method Test TOC Sight Glass Method Remove the fuel suction line. Install a sight…

Injectors and Fuel Lines Tool Number ST-434 Vacuum Gauge 0-763 mm-Hg [0 to 30 in. Hg] Used to check fuel inlet restriction. Hose adapters, Part…

Table of Contents Initial Check Initial Check TOC To check for a sticking pressure regulator, install a pressure gauge on the Compuchek™ fitting in the…

Table of Contents Stall Speed Check Time Speed Check Stall Speed Check List Stall Speed Check TOC Converter Transmissions Stall Speed The stall speed is…

Table of Contents Resistance Check Voltage Check Remove Install Resistance Check TOC Remove the wire. Make sure the remaining wire connection nut is tight. Tighten…

Table of Contents Inspect for Reuse Inspect for Reuse TOC Remove the fuel inlet connection and pulsation damper or the filter head damper assembly. Discard…

Table of Contents Remove Install Remove TOC If the check valve in the gear pump return elbow stays open or closed, replace the elbow. SMALL | MEDIUM | LARGE…