Important: This plug has an orifice hole that prevents an air lock from occurring and blocking the oil flow. 1. Install the oil cooler bypass…

1. Raise the vehicle and support with safety stands. 2. Remove the oil filter from the oil filter fitting (2 wheel drive only). Important :…

1. Install the flywheel to the crankshaft Notice: Refer to Fastener Notice in Caution and Notices. 2. Install the flywheel mounting bolts. Tighten Tighten the…

Important: Do not machine the flywheel, it is a replacement part only. 1. Disconnect both the battery negative cables from the batteries. Refer to Battery…

Tools Required J 39084 Crankshaft Rear Oil Seal Installer 1. Use the J 39084 to install the crankshaft rear oil seal to the crankshaft. 2.…

Important: Do not raise the engine block by the crankshaft balancer to perform this service procedure. 1. Disconnect both the battery negative cables from the…

Important: When a new camshaft is being installed, use caution when installing the camshaft. Always install new valve lifters, engine oil and oil filter must…

Notice: Perform TDC Offset Recovery procedure if the timing chain, timing gears, engine front cover, crankshaft position sensor, crankshaft or other components affecting the timing…

Important: Make sure the timing marks are aligned. 1. Install the crankshaft sprocket on the crankshaft. 2. Install the camshaft sprocket with the timing chain…

1. Disconnect both the battery negative cables from the batteries. Refer to Battery Cable in Engine Electrical. 2. Rotate the engine to TDC. 3. Remove…