Table of Contents Calibrate Calibrate TOC Install the dipstick into the dipstick tube housing. NOTE: Do not over-tighten the dipstick. Use clean 15W-40 oil to fill…

Table of Contents Preparatory Steps Remove Clean Pressure Test Install Finishing Steps Preparatory Steps TOC  WARNING  Coolant is toxic.  Keep away from children and pets.…

Table of Contents Lubricating Oil System Lubricating Oil System TOC Tool Number ST-1273 Pressure Gauge Used to measure the engine intake manifold pressure. Tool Number…

Table of Contents Measure Measure TOC NOTE: This procedure applies to STC engines only. This no-air check must be made on a dynamometer.   SMALL | MEDIUM | LARGE Next…

Table of Contents Initial Check Leak Test Initial Check TOC Check the STC plumbing. NOTE: Make sure the STC oil supply line is plumbed between the…

Table of Contents Test Test TOC The following procedure outlines the proper method which must be used to test the STC oil delivery system. NOTE: Because…

Table of Contents Remove Clean and Inspect for Reuse Install Remove TOC Remove the oil transfer tube. Refer to Procedure 007-040 in Section 7. SMALL | MEDIUM | LARGE…

Table of Contents Initial Check Remove Install Initial Check TOC Record the part number of the STC control valve from the data tag on the…

Table of Contents General Information Preparatory Steps Remove   CELECT™ STC Clean Install   CELECT™ STC Finishing Steps General Information TOC NOTE: Calibration requires special equipment…

Table of Contents General Information Preparatory Steps Measure Finishing Steps General Information TOC The static timing is relative to the amount of push tube travel…