Table of Contents Remove   CELECT™ STC Remove TOC CELECT™ NOTE: Excessive crosshead wear can result if the crossheads are not installed in their original locations.…

Table of Contents Remove Remove TOC Remove the push rods. NOTE: To prevent increased wear, mark each push rod as it is removed so it can…

Table of Contents Remove Remove TOC Remove the crossheads. Make sure to mark them appropriately so they can be installed in the same location and…

Table of Contents Remove Remove TOC Loosen the valve and injector adjusting screw lock nuts on each rocker lever. Turn the adjusting screws counterclockwise until…

Table of Contents Remove Remove TOC Disconnect the engine brake harness wire from the electrical connector on each engine brake housing. Remove the capscrews and…

Table of Contents Remove Remove TOC Remove the hose from the crankcase breather. Remove the ten capscrews from each rocker lever cover. Remove the rocker…

Table of Contents Remove Remove TOC Disconnect the intake air piping from the charge-air cooler to the inlet air connector. SMALL | MEDIUM | LARGE Next Disconnect the air…

Table of Contents Remove Remove TOC Lift up on the locking tab and pull the electrical connectors apart. Remove the sensor from the engine. SMALL | MEDIUM | LARGE…

Table of Contents Remove Remove TOC Disconnect the pressure signal line (1) from the lubricating pump fitting. Disconnect the rifle pressure supply line (3) from…

Table of Contents Remove Remove TOC Remove the demand flow cooling signal line between the cylinder block main oil rifle and the lubricating oil pump.…