Table of Contents Initial Check Initial Check TOC Valve Seal – Wear Worn valve seals are typically detected by excessive smoke at idle or when…

Table of Contents General Information Initial Check Preparatory Steps Remove Clean Inspect for Reuse   Cylinder Head Capscrews Install Finishing Steps General Information TOC The…

Cylinder Head Tool Number 3824591 Engine Barring Gear Used to engage the flywheel ring gear to rotate the crankshaft. Tool Number 3822513 Tappet Removal Tool…

Table of Contents General Information Preparatory Steps Remove Clean Inspect for Reuse Install General Information TOC The rear crankshaft seal is mounted in a housing…

Table of Contents Remove Install Remove TOC T-25 Torx Disconnect the four pin weather pack connector. Remove the engine position sensor. Remove the engine position…

Table of Contents General Information Remove Disassemble Assemble Install General Information TOC There are a number of power-related problems, including excessive lubricating oil consumption, smoke,…

Table of Contents General Information Preparatory Steps Remove Inspect for Reuse Measure Install General Information TOC The vibration damper controls the torsional vibration of the…

Table of Contents Remove Inspect for Reuse Install Remove TOC 3/8-Inch Square Drive Remove the drive belt. Refer to Procedure 008-002. SMALL | MEDIUM | LARGE Next 15 mm…

Table of Contents General Information Failure Analysis Inspection Install General Information TOC The piston rings for naturally aspirated and turbocharged engines differ.   Turbocharged (B)…

Table of Contents General Information Initial Check Preparatory Steps Remove Disassemble Clean Inspect for Reuse Install General Information TOC Overheating of the engine from a…