Table of Contents Install Install TOC NOTE: It is not necessary to time the air compressor on the NT engine. Although the Big Cam III through…

Table of Contents Install Install TOC Rotate the crankshaft until the accessory drive timing marks on the camshaft gear are at approximately the 1:00 o’clock…

Table of Contents Install Install TOC Use compressed air to flush the lines and remove any loose dirt particles. Install the fuel lines. Install any…

Table of Contents Install Install TOC Install a new o-ring onto the engine position sensor. Install the new sensor into the mounting hole in the…

Table of Contents Install Install TOC Install a new rectangular sealing ring into the lubricating oil pump mounting flange. Use clean vegetable oil to lubricate…

Table of Contents Install Install TOC Install the demand flow cooling signal line. Tighten the signal line fittings. Torque Value:  9  n.m  [80 in-lb] SMALL | MEDIUM | LARGE Next Make sure that…

Table of Contents Install Install TOC Use 15W-40 oil to lubricate the shaft, the gears, and the bushings. Make sure to lubricate the area between…

Table of Contents Install Install TOC Install the bracket to the viscosity sensor. Install the two bracket capscrews and tighten. Torque Value:  27  n.m  [239 in-lb] Connect the flexible…

Table of Contents Install Install TOC Make sure the new sensor has an o-ring. Install the new sensor into the engine. Tighten the sensor. Torque…

Table of Contents Install Install TOC Use new gasket(s) and install the intake manifold onto the cylinder head mounting surfaces. Install and tighten the nine…