Symptom Tree t050
| Cause | Correction |
|---|
Refer to Engine Noise Diagnostic Procedures — General Information at the end of this section before using this symptom tree.
|
Electronic fault codes active or high counts of inactive fault codes |
Refer to Section TF in the Troubleshooting and Repair Manual CELECT™ Plus System, Bulletin 3666130, or the Troubleshooting and Repair Manual CELECT™ Electronic Control System L10, M11, and N14 Engines, Bulletin 3666084. |
 |
|
Lubricating oil pressure is below specification |
Check the oil pressure. If the pressure is low, refer toProcedure 007-028. |
|
|
Lubricating oil level is below specification |
Check the oil level. Verify the dipstick calibration and the oil pan capacity. Fill the system to the specified level. Refer to Procedures 007-009 and 007-025. |
|
|
Lubricating oil is thin or diluted |
Refer to Section F. If the oil pressure is low, refer to the Lubricating Oil Pressure Low symptom tree. |
|
|
Flywheel or flexplate capscrews are loose or broken |
Check the flywheel or flexplate and the mounting capscrews. Refer to Procedure 016-005. |
|
|
Torque converter is loose |
Check the torque converter. Refer to the OEM service manual. |
|
|
Main bearing capscrews are loose, worn or not tightened correctly |
Check the torque on the main bearing capscrews. Inspect the capscrews for wear. Refer to Procedure 001-006. |
|
|
Main bearings are damaged or worn, or the wrong bearings are installed |
Inspect the main bearings for damage, excessive wear, and the correct part number. Refer to Procedure 001-006. |
|
|
Crankshaft journals are damaged or out of round |
Inspect the crankshaft journals. Refer to the Shop Manual M11 and ISM Engines, Bulletin 3666075. |
