Centinel System – Repair Manual – 016-002   Engine Support Bracket, Front

WARNING  This assembly weighs 23 kg [50 lb] or more. To reduce the possibility of personal injury, use a hoist or get assistance to lift this assembly.

• Use a hoist or lifting fixture to support the front of the engine.
• Remove the fan and water pump drive belt. Refer to Procedure
  008-003.
• Remove the fan and water pump belt tensioner if a low mount tensioner is used. Refer to Procedure
  008-080.
• Remove the vibration damper and the crankshaft pulley. Refer to Procedure
  001-052.

WARNING  This assembly weighs 23 kg [50 lb] or more. To reduce the possibility of personal injury, use a hoist or get assistance to lift this assembly.

Remove the two capscrews that attach the support to the equipment frame.

Use the hoist to lift the weight of the engine off the front support.

Remove the six mounting capscrews and the front engine support.

Remove the rubber engine mounts.

WARNING  When using a steam cleaner, wear safety glasses or a face shield, as well as protective clothing. Hot steam can cause serious personal injury.

WARNING  When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer’s recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury.

WARNING  Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury.

Clean the parts with steam or solvent.

Dry the parts with compressed air.

Inspect the engine mounts for cracks or deterioration.

Inspect the engine support bracket for cracks or damage.

Inspect the capscrew threads for damage.

Install the engine support bracket and the six mounting capscrews.

Tighten the capscrews.

Torque: 97 N•m + 60 deg [72 ft-lb + 60 deg]

Install the rubber engine mounts into the crossmember.

WARNING  This assembly weighs 23 kg [50 lb] or more. To reduce the possibility of personal injury, use a hoist or get assistance to lift this assembly.

Lower the front of the engine to the rubber engine mounts.

The capscrew holes in the support bracket
must be aligned with the capscrew holes in the engine mounts.

Install the two capscrews in the support bracket and engine mount. Tighten to the manufacturer’s specifications.

Remove the lifting fixture or the hoist from the engine.

• Install the vibration damper and the crankshaft pulley. Refer to Procedure
  001-052.
• Install the fan and water pump drive belt tensioner. Refer to Procedure
  008-080.
• Install the fan and water pump drive belt. Refer to Procedure
  008-003.